200-480V high bay solutions

Many LED & conventional lighting products are designed to derive power from standard 120V or 240V power sources. Power supplies for these devices (typically called “Drivers”) may be designed to operate at either of these voltages, or often, at any voltage between 100-277V (universal input supplies).

The challenge

Many commercial & industrial installations receive primary power at 347V (in Canada) or 480V (US), which often exceeds the rated input voltage for most lighting products. It is hazardous to operate a device beyond its rated voltage & is not acceptable by the local electrical authority. LED High Bay Light is the most popular light used in industrial applications. That’s why many electricians in North America are looking for a 347V or 480V input High Bay Light. Note: Electrical supply in both Canada and the US typically operates at 60 Hz (frequency).

Nominal standard supply voltages in Canada
Nominal Supply Voltage – Canada Typical Uses
600V 3-phase (line-to-line) High-Power Industrial and Commercial loads
347V 3-phase (line-neutral) High-Power Industrial and Commercial loads
208V 3-phase (line-to-line) Commercial, Industrial and some large Residential loads
120V 3-phase (line-to-neutral) Commercial, Industrial and some large Residential loads
240V split phase (line-to-line) Residential large loads
120V (line-to-neutral) Residential, common use

Note:  Nominal standard supply voltages in the USA

The U.S. has many similarities with Canada on lower voltage side (208/120V 3-phase & 240/120V split-phase supply) but differs on the higher voltage side as follows:

Nominal Supply Voltage – U.S. Typical Uses
480V 3-phase (line-to-line) High-Power Industrial & Commercial loads
277V 3-phase (line-to-neutral) High-Power Industrial & Commercial loads

What happens if the supply and fixture voltages are incompatible?

A supplementary device that reduces or “steps” the voltage down is required.  This is when an installer would use a step-down autotransformer.

Autotransformers are a simple and reliable style of transformer consisting of a single coil wound around a steel core that takes a higher voltage input (e.g. 347 or 480V) and “steps it down” to a lower voltage (e.g. 240V or 120V).

Tip: These transformers must bear Safety Certification markings to show compliance with safety standards to the local electrical inspection authority.

Don’t want to use autotransformers? Then try our 347V or 480V input High Bay Light.

Fireflier provides a much easier solution which allows you to use our high bay light directly with 347V or 480V input voltage without transformers. Adopted with our customized AC200-480V Sosen or Meanwell driver, our Ripple UFO LED High Bay Light and Crown UFO LED High Bay Light can work normally under AC277/AC347/AC480V input high voltage. The available power is 80W, 100W, 150W, 200W, 240W.

Ripple UFO LED High Bay Light 200-480V

A customized high voltage Sosen driver is used for our Ripple High Bay Light 200-480V. Below is brief information for this driver.

· 180-528Vac Input · Efficiency up to 91% · Optional dimming function: 0-10V, PWM, Resistor; Timing

· IP65 rated; Suitable for Dry, Damp and Wet Locations · Protections: SCP, OTP, OVP

· Metal case with full potted for hazardous scenarios · Surge Protection: L/N-PE: 4KV, L-N 2KV

· 5 years warranty

For your reference, hereby we enclose some photos of our 150W UFO LED High Bay light with AC200-480V input voltage:

200-480V LED High Bay Light 150W

347V 480V LED High bay light

High voltage LED High bay lamp

Crown UFO LED High Bay Light 200-480V

A customized high voltage Meanwell driver is used for our Crown High Bay Light 200-480V. Below is brief information for this driver.

*Wide input range 180~528VAC

*Metal case, IP67/IP65 design for indoor or outdoor installations

*Built-in active PFC function

*Function options:
output adjustable via potentiometer; 3 in 1 dimming (0~10Vdc or 10V PWM signal or resistance, dim-to-off); timer dimming; smart timer dimming

*Type “HL” LED drivers for use in Class I, Division 2 hazardous (Classified) location luminaries (except for HVG-65 and HVGC-65/100)

*Suitable for LED street lighting and outdoor LED lighting applications

*5 years warranty

For your reference, hereby we enclose some photos of our 150W UFO LED High Bay light with AC200-480V input voltage:

ufo led high bay lamp 200-480v

347V 480V LED High bay lighting

Crown UFO LED High bay 200-480V

Besides, we provide also other industrial lights with high voltage 347V 480V, including: LED flood light, LED sport light, LED Vapor Tight light, etc. If you are looking for high voltage AC347V or AC480V high bay light, please consult us freely.

    We're always excited about your message, so feel free to get in touch, we will reply you in 12 hours.

                           

    Spread the love

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    1
    WhatsApp or Wechat
    Scan the code
    Welcome to Fireflier
    Hello
    Can we help you?